Prerunner Tech

Fabtech Ranger Edge Spindle Lift Install

Now you will need a dead-blow hammer, and after removing the top and bottom nut holding the spindle, hit the side of the spindle towards the top ball joint mount to loosen it.

The owner of this truck wanted to have the bearings replaced, so that was the next step.

Using a grinder Robby cut the factory lower a-arm to make room for the new Fabtech lift spindle. YouÂ’ll see from the picture where to cut. Also take note of the factory steering stop that is circled. It will be removed in a later step.

Related posts

New Toyota Tacoma Mid-Travel Suspension Kit

administrator

White Night Rear Lighting System

administrator

Flowmaster Muffler Increases Power and Saves Gas

administrator